Answer：In robots, actuators are generally divided into two types: hydraulic drive and motor drive, among which motor drive is the most common. This article mainly discusses the selection of motors in general robot drive mechanisms.
Answer：DC reduction motors have penetrated into all walks of life in modern life, providing more intelligent and automated life application scenarios and equipment; in order to better meet power requirements and performance requirements, customized power mo...
Answer：Some car repair friends have reported that the wiring sequence of the main control plugs of some controllers has changed. We would like to remind everyone to pay attention to this and also popularize the coping methods.
Answer：Permanent magnet synchronous motors can be divided into outer rotor structures and inner rotor structures according to the position of the rotor in the motor . The difference is whether it rotates inside or outside. If it rotates inside, it is an inn...
Answer：According to the structure of stepper motor, it can be divided into three types: permanent magnet type, reactive type and hybrid type. There is more than one type of stepper motor, and one type of stepper motor has two windings. The two windings a...
Answer：Motor overload refers to the state where the current required by the motor during operation is greater than its rated current, causing the motor to operate overloaded. If this situation continues to occur, it will bring a series of serious consequenc...
Answer：when measuring the insulation resistance before the product is offline, it is best to conduct a hot insulation resistance test immediately after the product is undergoing an aging test, or after high-temperature aging. At this time, the measured resi...
Answer：By simply understanding the basic situation of the controller, we can have a rough idea and an impression of the importance of the controller. The controller is the second most expensive accessory in the whole vehicle assembly. According to the data ...
Answer：When the motor is running under load, its internal total loss is converted into heat energy, which increases the temperature of the motor. The insulation material in the motor has the poorest heat resistance. If the load of the motor is too large, th...
Answer：A servo motor is a micro motor used as an actuator in an automatic control device. Its function is to convert electrical signals into angular displacement or angular velocity of the rotating shaft.
XINDAAll rights reserved(copyright) Shandong Xinda Motor Co., Ltd.
