Answer:the effect of speed on motor performance is a complex issue that involves the balance of multiple factors. When selecting a motor, it is necessary to comprehensively consider application requirements, power requirements, torque requirements, balance ...
Answer:The high efficiency mentioned here does not only mean that the efficiency at the rated power point is higher than that of ordinary three-phase asynchronous frequency modulation motors, but refers to its average efficiency in the entire speed regulati...
Answer:In robots, actuators are generally divided into two types: hydraulic drive and motor drive, among which motor drive is the most common. This article mainly discusses the selection of motors in general robot drive mechanisms.
Answer:DC reduction motors have penetrated into all walks of life in modern life, providing more intelligent and automated life application scenarios and equipment; in order to better meet power requirements and performance requirements, customized power mo...
Answer:Some car repair friends have reported that the wiring sequence of the main control plugs of some controllers has changed. We would like to remind everyone to pay attention to this and also popularize the coping methods.
Answer:Permanent magnet synchronous motors can be divided into outer rotor structures and inner rotor structures according to the position of the rotor in the motor . The difference is whether it rotates inside or outside. If it rotates inside, it is an inn...
Answer:According to the structure of stepper motor, it can be divided into three types: permanent magnet type, reactive type and hybrid type. There is more than one type of stepper motor, and one type of stepper motor has two windings. The two windings a...
Answer:Motor overload refers to the state where the current required by the motor during operation is greater than its rated current, causing the motor to operate overloaded. If this situation continues to occur, it will bring a series of serious consequenc...
Answer:when measuring the insulation resistance before the product is offline, it is best to conduct a hot insulation resistance test immediately after the product is undergoing an aging test, or after high-temperature aging. At this time, the measured resi...
Answer:By simply understanding the basic situation of the controller, we can have a rough idea and an impression of the importance of the controller. The controller is the second most expensive accessory in the whole vehicle assembly. According to the data ...